10. Synchronization ......................................................................................................... 64
10.1. Remarks in using WX Navi ................................................................................... 64
10.1.1. The two WX-7000 recorders which operate in synch must be connected to the same
subnet. ......................................................................................................... 64
10.1.2. No other WX-7000 recorders than the Master and Slave units are to be connected to
the subnet. .................................................................................................... 64
10.1.3. When you run two WX Navi software for two WX-7000s recorders operating in synch,
each WX Navi must be run on the another PC. ................................................ 64
10.2. Cable connection ................................................................................................ 64
10.2.1. Synchronization cable .................................................................................... 64
10.2.2. Ethernet cable ............................................................................................... 64
10.3. Connection check ............................................................................................... 65
10.3.1. Starting the connection check ......................................................................... 65
10.3.2. Connecting WX Navi ...................................................................................... 66
10.4. Synchronized recording ....................................................................................... 67
Step 1 Switch from VIEW mode to REC mode. ............................................................. 67
Step 2 Setting recording media, sampling frequency and A/D converter on master unit .. 67
Step 3 System/channel settings on each WX-7000 ....................................................... 68
Step 4 Close all setting dialogs .................................................................................... 68
Step 5 Start synchronized recording on Master unit ...................................................... 68
10.5. Synchronized playback ........................................................................................ 69
Step 1 Select playback mode and file on Slave unit ...................................................... 69
Step 2 Select playback mode and file on Master Unit .................................................... 69
Step 3 Control play/stop on Master unit ....................................................................... 70
Step 4 Switch from VIEW mode to REC mode on the Slave unit .................................... 70
Step 5 Switch from VIEW mode to REC mode on Master unit ........................................ 70
To Next Page
Loading...
Need help?
General
