6. TERMINAL FILE PROGRAMMING
EO3-11106
6.18 Read/Reset Report Name Programming
6-94
3) Example
To program “X_DP_PROFIT” instead of standard program data “X_PROFIT” for Report No. 21.
Operation LCD Display Remarks
When the ECR is being outside a sale
and in SET mode, depress the [↓] key.
The cursor is moved on to “2 NAMES”.
Depress the [2] or [Enter] key.
“2 NAMES” is selected.
Depress the [↓] key nine times.
The cursor is moved on to
”0 X/Z REPORT NAME”.
Depress the [0] or [Enter] key.
” 0 X/Z REPORT NAME” is selected.
Depress the [↓] key twenty times, then
depress the [Enter] key.
(Report No. 21 (“X_PROFIT”) is
selected.)
While ? is shown on the upper-right corner
of the LCD display screen, the [?] key
depression results in that the following
guidance message appears on the LCD
display.
The [C] key depression clears the
report name already programmed.
The report name already programmed is
displayed.
Input a desired name.
Numbers of programmed characters and of
programmable characters are displayed on
the 7-segment numeric display.
Example of key operation)
[X] 515 [#] [D] [P] 515 [#] [P] [R] [O] [F] [I]
[T] [Enter]
The [Enter] key depression results in
that the input name is entered and
displayed.
When the [Enter] key is depressed, the
programmed data is printed.
(continued on the next page)
To Next Page
Loading...
