6. TERMINAL FILE PROGRAMMING
EO3-11106
6.6 Commercial Message Programming
6-49
6.6 Commercial Message Programming
A maximum of 96 characters of Commercial Message (32 characters x 3 lines) to be printed on the receipt is
programmed here.
Any time outside a sale
Mode Lock: SET
1) Menu Tree
2) Operation Flowchart
Main Menu
Depress [1] or [Enter].
“1 MESSAGES” for various message programming is selected.
Depress [1] or [Enter].
“1 COMMERCIAL MESSAGE” is selected.
The message already programmed is displayed.
[Enter]
The ECR enters the 1st line message input mode.
Input a message in the 1st line.
A maximum of 32 one-byte or 16 two-byte characters are input.
[Enter]
The 1st line message is entered and the programmed data is printed.
[Enter]
The ECR enters the 2nd line message input mode.
Input a message in the 2nd line.
A maximum of 32 one-byte or 16 two-byte characters are input.
[Enter]
The 2nd line message is entered and the programmed data is printed.
[Enter]
The ECR enters the 3rd line message input mode
Input a message in the 3rd line.
A maximum of 32 one-byte or 16 two-byte characters are input.
[Enter]
The 3rd line message is entered and the programmed data is printed.
[End]
This programming is ended. A long receipt is issued and the display
returns to Main Menu screen.
NOTES:
1. For each line, a maximum of 32 one-byte characters or 16 two-byte characters can be entered.
A combination of both types is also available.
2. If three blank lines are programmed for a commercial message, their portions on the receipt will be closed.
If at least one line message is programmed, the other two lines will be blank.
*: To program a message in a desired line, move the cursor there with
the [
↓
] key then depress the [Enter] key.
*
OPERATION
CONDITION
To Next Page
Loading...
