TEC MA-600 Series - Set

6. TERMINAL FILE PROGRAMMING EO3-11106
6.5 System Option Programming
6-22
System Option Table
Standard Bit Set (auto-set by RAM Clear)
ADDRESS NO. CONTENTS
0
1 NON-PRINT OPTION I
BIT
NO.
ITEM SELECTIVE STATUS
STANDARD
STATUS
REMARKS
RESET
PRINT
*
1
Time (on Sale Receipt,
Report, Program
Receipt)
SET
NON-PRINT
RESET
PRINT
*
2
Sale Item Count on
each Sale Receipt
SET
NON-PRINT
RESET
PRINT
*
3
Subtotal Amount print
by [ST] key on Receipt
and Journal
SET
NON-PRINT
NOTE 1 below
RESET
*
4
-- vacant --
SET
RESET
PRINT
*
5
Customer Count for
each Department on
Department Reports
SET
NON-PRINT
RESET
PRINT
*
6
Sale % of each
Department and Group,
on Department and
Group Reports
(NOTE 2)
SET
NON-PRINT
Both Bit 5 & 6 RESET:
Prints sales % of each
Department and Group
RESET
PRINT
*
7
Gross Profit of each
Department, on
Department Reports
SET
NON-PRINT
“Department Gross
Profit Read Reports”
can be issued
regardless of this status
RESET
PRINT
*
8
Sales Person on Sale
Receipt and Remote
Slip
SET
NON-PRINT
NOTE 3 below
NOTE 1: This bit status selection is also applied to the following cases in which the subtotal amount is automatically printed.
• Sale Finalization, % Operation, Amount Discount, and Special Rounding Spec.
NOTE 2: • The sale % of a department = (That Department) / (Sum of Positive Department)
(When the “Sum of Positive Department” is zero or negative, the sale % of 0% will be printed.)
• The sale % of a negative Status Department is not printed.
NOTE 3: If SET, no printing is performed on the receipt printer and the Remote Slip Printer during the salesperson entry, however, it is
performed on the journal regardless of the setting.