6. TERMINAL FILE PROGRAMMING
EO3-11106
6.40 Special Rounding Process Setting, 2-digit type
6-163
6.40 Special Rounding Process Setting, 2-digit type
For Special Rounding and Denmark rounding, the pre-rounded value of the two least effective digit and the post-
rounded value are set here. This operation is effective when the option “Special Rounding ACTIVE” and “2 digits
subject to Special Rounding” are selected (System Option Address No. 33, Bit No. 3 SET & Bit No. 4 SET).
Any time outside a sale
Mode Lock: SET
1) Menu Tree
2) Operation Flowchart
Main Menu
ECR is being outside a sale and in SET mode.
Depress [↓] five times then [Enter].
or
Depress [6].
“6 OTHER” is selected.
Depress [↓] six times then [Enter].
or
Depress [7].
“7 ROUND TBL 2 DIGITS” is selected.
Maximum value of the range of the digit
subject to round (2 digits)
+
Post-rounded value (2 digits)
Maximum value of the range of the digit subject to round: 00 to 99
Post-rounded value: 00 to 99
[Enter]
[End]
This setting is ended. A long receipt is issued and the display
returns to Main Menu screen.
NOTES:
1. When the “Post-rounded Value” is to be 100 (i.e. the final break point), the break entry is automatically set
(refer to the example below). Therefore, it does not need to be entered. Entering a value larger 99 for the
Post-rounded value will not cause an error. However, the rounding process will occur only on the two least
effective digits in sales entries.
2. A maximum of 10 breaks can be programmed.
3. Values for Sweden rounding are set after performing a RAM Clear.
4. Example of Sweden rounding
For the Sweden rounding, the amount total is rounded as shown below.
Pre-rounded value of the
two least effective digits
Post-rounded value
0 to 24 00
25 to 74 50
75 to 99 100
*
*: Repeat for the next break entries (max. 10 breaks).
OPERATION
CONDITION
To Next Page
Loading...
Need help?
General
