To Next Page

To Previous Page

4. SYSTEM START-UP PROCEDURE

EO3-11106

4. SYSTEM START-UP PROCEDURE

4- 1

4. SYSTEM START-UP PROCEDURE

Case 1: To start-up using the MA-600 terminal only

RAM Clear (Chapter 5)

All the programming operations required

for the terminal (Chapter 6)

Case 2: To start-up by installing programming data from the PC

CAUTION!

< Precautions for connection to PC >

1. The USB cable should be connected to the ECR each time a PC sends/receives data to/from the ECR.

If the USB cable is kept connected to the ECR for a long period of time, data transfer may not be

performed properly.

2. When the ECR is connected to a PC with the USB cable, be sure to turn on the ECR in any mode other

than BLIND mode. Otherwise, the ECR may not start.

RAM Clear (Chapter 5)

PC Transmission Information Setting

(See the next page.)

Turn off the ECR.

Connect a PC to the ECR via the USB

cable.

Turn on the ECR in any mode other than

BLIND mode.

DLL (Down Line Loading) the data

programmed on the PC to the terminal.

Perform this setting only for selecting

any other than the default value.

For details, refer to the MA-600 Series

PC Programming Tool Manual.

TEC MA-600 Series Programming Manual

Other manuals for TEC MA-600 Series