6. TERMINAL FILE PROGRAMMING
EO3-11106
6.5 System Option Programming
6-28
System Option Table
Standard Bit Set (auto-set by RAM Clear)
ADDRESS NO. CONTENTS
568
11 NON-PRINT OPTION III
BIT
NO.
ITEM SELECTIVE STATUS
STANDARD
STATUS
REMARKS
RESET
*
1
-- vacant --
SET
RESET
*
2
-- vacant --
SET
RESET
*
3
-- vacant --
SET
RESET
*
4
-- vacant --
SET
RESET
COUNT
5
[C] (Clear) Key Counter
on Reports
SET
NON-COUNT
*
RESET
PRINT
6
Financial and Cashier
Daily Read Counter on
Reports
SET
NON-PRINT
*
NOTE 1 below
RESET
*
7
-- vacant --
SET
RESET
PRINT (NOTE 2 below)
8
[C] (Clear) Key on
Journal
SET
NON-PRINT
*
NOTE 1: If RESET, when performing a financial read/reset or cashier read/reset operation, their respective read counter (X counter) is
printed on the report. (For details, please refer to the Table below.) The read counter (X counter) increases by one regardless of
this bit status.
Table: X counter and Z counter print
Daily GT
X Counter Z Counter X Counter Z Counter
Daily Read Printed --- --- ---
Daily Reset Printed Printed --- ---
GT Read --- --- Printed ---
GT Reset --- --- Printed Printed
NOTE 2: The descriptor “CLEAR” (programmable) is printed on Journal every time the [C] key is operated in the REG mode to clear a
numeric value or declaration key error. However, it will not be printed when the [C] key is depressed to clear an error condition.
Additionally, this printing will not be recorded in the MGR or - mode. It will be performed neither on the Receipt nor Remote Slip
Printer in any mode.
- - Address Nos. 12 to 16 are vacant. - -
To Next Page
Loading...
Need help?
General
