TEC MA-600 Series - Page 70

6. TERMINAL FILE PROGRAMMING EO3-11106
6.6 Commercial Message Programming
6-50
3) Example:
To program the following Commercial Message.
Operation LCD Display Remarks
When the ECR is being outside a sale
and in SET mode, depress the [1] or
[Enter] key.
Depress the [1] or [Enter] key.
The message already programmed is
displayed.
(To program a message in a desired
line, move the cursor there with the [↓]
key then depress the [Enter] key.)
While ? is shown on the upper-right corner
of the LCD display screen, the [?] key
depression results in that the following
guidance message appears on the LCD
display.
The [Enter] key depression allows the
ECR to enter the 1st line message
input mode. (The [C] key depression
clears the message already
programmed.) The 1st line message is
input.
Numbers of programmed characters and of
programmable characters are displayed on
the 7-segment numeric display.
Example of key operation)
[→] [→] [→] [→] [→] [O] [A/a] [p] [e] [n]
[→] [→] [3] [0] [8] [#] [3] [1] [0] [#] [3] [0]
[0] [#] [3] [0] [0] [#] [a] [m] [→] [t] [o] [→]
[3] [0] [7] [#] [3] [1] [0] [#] [3] [0] [0] [#] [3]
[0] [0] [#] [p] [m] [Enter]
The [Enter] key depression results in
that the input message is entered and
displayed.
When the [Enter] key is depressed, the
message programmed in the 1st line is
printed.
The [Enter] key depression allows the
ECR to enter the 2nd line message
input mode. (The [C] key depression
clears the message already
programmed.) The 2nd line message
is input.
Numbers of programmed characters and of
programmable characters are displayed on
the 7-segment numeric display.
Example of key operation)
[→] [→] [→] [→] [C] [A/a] [l] [o] [s] [e] [d]
[3] [1] [0] [#] [→] [e] [v] [e] [r] [y] [→][A/a]
[W] [A/a] [e] [d] [n] [e] [s] [d] [a] [y] [Enter]
(continued on the next page)
O p e n 8 : 0 0 a m t o 7 : 0 0 p m
C l o s e d : e v e r y W e d n e s d a y
Line No. 1
Line No. 2
Line No. 3
Number of programmed characters
Number of programmable characters