6. TERMINAL FILE PROGRAMMING
EO3-11106
6.5 System Option Programming
6-19
Setting Example)
To set Address No. 1 with the following requirements:
(Refer to the Address No. 1 table on the subsequent page.)
Bit No. 1: Time NON-PRINT (SET status)
Bit No. 3: Subtotal NON-PRINT (SET status)
Other bits will be selected to “RESET” status.
Operation LCD Display Remarks
When the ECR is being outside a sale
and in SET mode, depress the [↓] key
five times.
The cursor is moved on to “6 OTHER”.
Depress the [6] or [Enter] key.
Depress the [↓] key.
The cursor is moved on to “2 SYSTEM
OPTION”.
Depress the [2] or [Enter] key.
Address No. list is displayed. Select a
desired Address No. with the [↑] or [↓]
key.
In this example, Address No. 1
(01NON-PRINT) is selected.
While ? is shown on the upper-right corner
of the LCD display screen, the [?] key
depression results in that the following
guidance message appears on the LCD
display.
For the selected Address No., the Bit
Numbers currently programmed are
displayed on the 7-segment Numeric display.
With the [Enter] key depression,
Address No. 1 setting is displayed.
The [?] key depression results in that the
following guidance message appears on the
LCD display.
(continued on the next page)
To Next Page
Loading...
