TEC MA-600 Series - Page 66

6. TERMINAL FILE PROGRAMMING EO3-11106
(Revision Date: Feb. 23, 2007)
6.5 System Option Programming
6-46
System Option Table
Standard Bit Set (auto-set by RAM Clear)
ADDRESS NO. CONTENTS
0
42 OPTIONAL FUNCTION XVI
BIT
NO.
ITEM SELECTIVE STATUS
STANDARD
STATUS
REMARKS
RESET
*
1
-- vacant --
SET
RESET
*
2
-- vacant --
SET
RESET
*
3
-- vacant --
SET
RESET
*
4
-- vacant --
SET
RESET
*
5
-- vacant --
SET
RESET
*
6
-- vacant --
SET
RESET
PRINT
*
7
Z Counter Print on
Reset Reports
SET
NON-PRINT
NOTE 1 below
RESET
NON-PRINT
*
8
Consecutive No. Print
immediately after the
previous daily financial
reset
SET
PRINT
NOTE 2 below
NOTE 1: RESET: The Z counter is printed on the reset reports.
SET: The Z counter is not printed on the reset reports, however, only “ z” is printed.
This counter increases by one regardless of this bit status.
NOTE 2: If SET status is selected, the consecutive No. immediately after the previous daily financial reset is printed on the daily financial
reset report. (Columbia specification)
After a RAM Clear or Data Clear, the consecutive No. will be cleared.
- - Address Nos. 43 to 46 are vacant. - -