6. TERMINAL FILE PROGRAMMING
EO3-11106
6.15 Print Line Item Name Programming
6-78
3) Example
To program the amount mark “€” in Item Code 7: (The amount mark has not been preset as the standard
program data).
Meanwhile, the names of the other items in the Item Code 7 should remain unchanged as the standard
program data (i.e. “@” for Unit Price Symbol and “ITEM” for Sale Item Count Symbol).
Operation LCD Display Remarks
When the ECR is being outside a sale
and in SET mode, depress the [↓] key.
The cursor is moved on to “2 NAMES”.
Depress the [2] or [Enter] key.
“2 NAMES” is selected.
Depress the [↓] key six times.
The cursor is moved on to
”7 PRINT ITEM NAME”.
Depress the [7] or [Enter] key.
”7 PRINT ITEM NAME” is selected.
Depress the [↓] key six times, then
depress the [Enter] key.
(Item code 7 (“@ ITEM ”) is selected.)
While ? is shown on the upper-right corner
of the LCD display screen, the [?] key
depression results in that the following
guidance message appears on the LCD
display.
The [C] key depression clears the print
line item name already programmed.
The print line item name already
programmed is displayed.
Input a desired name.
Numbers of programmed characters and of
programmable characters are displayed on
the 7-segment numeric display.
Example of key operation)
400[#] 900[#] [I] [T] [E] [M] [→] [Enter]
The [Enter] key depression results in
that the input name is entered and
displayed.
When the [Enter] key is depressed, the
programmed data is printed.
(continued on the next page)
To Next Page
Loading...
