14. Tension the tread belt according to the procedure: $”6.2.3 INSTALLATION OF A NEW
TREAD BELT-BELT REPLACEMENT”.
15. Install the antistatic brush.
For details, refer to the disassembly procedure (see the attached video):
15 - Assembling the power unit, untistatic brush and low kit
16. Completely ret the equipment. Remember to connect all the connectors.
INSPECTION TEST:
_Visual inspection of the integrity of the new tread belt t on the equipment and that there is no
wear.
_Test duration:approx. 30 sec: with the equipmenton, start an exercise (QUICK START) and check
that the tread belt moves smoothly, that it is not noisy and that the equipment gradient and speed
vary as the position of the joystick changes.
[Range: gradient: minimum-average-maximum; speed: minimum-average-maximum].
TECHNOGYM RUN Technical Service Guide
Rev. 1.0
- 58 - TSG-00284-EN- Uncontrolled copy if printed
To Next Page
Loading...
