Technogym FLEXability ME05 - Replacing the Encoder Cable

FLEXability LINE: Service & Maintenance Manual - rev. 1.0
5.3. THE ENCODER CABLE HAS TO BE REPLACED
5.3.1. ANTERIOR
Figure 5.3-1
To replace the encoder cable / tape, proceed as
follow:
1. Disassemble the encoder device as detailed
in charter 6 of this manual.
2. Pass the cable / tape inside the machine
frame as shown in the figure to side.
Figure 5.3-2
3. When the cable come out in the lower side of
the frame, pay attention to correctly route it
on the rollers indicated by the arrows.
Check that the cable/tape is not twisting
round the lever.
Continued on following page →
Page 5.3
All manuals and user guides at all-guides.com