FLEXability LINE: Service & Maintenance Manual - rev. 1.0
Page 6.10
6.6. ELBOW REST UPHOLSTERY
Figure 6.6-1
1. Back off the 3 screws a using a 4mm hex
wrench.
2. Remove the display casing b.
During the reassembly procedure, pay
attention to place the upper edge of the
casing in the slot of the handlebar.
Figure 6.6-2
3. Back off the 4 screws c that are fixing the
timer/encoder display, using a Phillips
screwdriver.
4. Back off the 4 screws d that are fixing the
elbow rest upholstery, using 6mm hex
wrench.
Figure 6.6-3
5. Pass the timer/encoder assembly e through
the hole of the elbow rest f and remove the
upholstery.
To reassemble the elbow rest upholstery, carry
out the above steps in reverse order.
To Next Page
Loading...
