Technogym Forma - Viewing the Working Parameters; Hours of Machine Operation; Hours of Tread-Belt Motor Operation; Minutes of Up-Down Motor Operation

FORMA: Service & Maintenance manual - rev. 3.0
Page 9.2
9.2. VIEWING THE WORKING PARAMETERS
In order to check the state of wear of the machine and correctly carry out routine machine
maintenance, a special procedure is provided for viewing the values of the working parameters. It is
called up by simultaneously pressing the “1”, “3” and “4” keys with the machine in standby mode.
The machine display shows:
P A S S W O R D
0
To access the procedure, type in the password which protects against unauthorized use. After typing
in the password “1508” and pressing “Enter” to proceed, the machine display shows:
9.2.1. H
OURS OF MACHINE OPERATION
The total hour count of machine on-time.
O N H O U R S =
X X
This value is not updated if it is less than 20 minutes.
Press the “Enter” key to proceed, or “Clear” to interrupt.
9.2.2. H
OURS OF TREAD
-
BELT MOTOR OPERATION
The total hour count of tread-belt motor operating time.
M O T O R H O U R S =
X X
Press the “Enter” key to proceed, “Clear” to interrupt.
9.2.3. M
INUTES OF UP
-
DOWN MOTOR OPERATION
The total minute count of up-down motor operating time.
U P - D O W N M I N =
X X
Press the “Enter” key to proceed, “Clear” to interrupt.
9.2.4. D
ISTANCE
C
OVERED
The number of Km covered by the machine.
K M C O V E R E D =
X X
Press the “Enter” key to proceed, “Clear” to interrupt.