Technogym SKILLROW - Troubleshooting; Heart Rate Monitoring Issues; Display and Grip Issues; Braking Efficiency Issues

SKILLROW:
Technical Service Guide - Rev. 1.1
Page 29e-mail: support@technogym.com
Figure 12: low kit board (detail of Fuse in F3)
3.2.6 EXTERNAL POWER SUPPLY
The SKILLROW is a self-powered equipment, therefore during the exercise, the equipment re-
charges the baery, that allows the U-I to function, not requiring external power supply.
The external power supply is not provided with the equipment, but if the baery discharged you
should use the following type of power supply to recharge the baery: 24 Vdc 0.5A jack 5.5x2.1.
The TG external power supply 0WR01188xx (MYCYCLING power supply) is an example of an
applicable power supply, already tested with the SKILLROW.
If you do, for a long time, power exercises, with magnetic braking, and you never normally row,
in the long term the equipment is not energetically self-sucient: in this case we recommends cu-
stomers to continuously use the external power supply.
To keep the product turned on, the grip must be actuated. If the display turns o immediately
when the movement is interrupted and does not turn back on, the baery must be recharged. After
3 strong rows, the display must remain on for 1 minute. If it turns o after a few seconds, recharge
the baery.