Technogym SKILLROW - Reading The Position Of The Knob; Reading The Value Calculated By The Low Kit

6.2.6.2 READING THE POSITION OF THE KNOB
Command Notes
Command @RKNOBPOS#
Shows the position of the knob. It returns a value
between 1 and 13.
Table 42
6.2.6.3 READING THE VALUE CALCULATED BY THE LOW KIT
Command Notes
Command @DUMPLK#
Shows the values currently calculated by the low
kit.
Table 43
Below, an example of the response of the console for the command @DUMPLK#:
!DUMPLK:TIME=835 SPM=25.316456 RPM=2351.499268 POWER=327.312317 DRAG_FAC-
TOR=130.546371 SPEED=4.889541 PACE=102.259087 HR=0 STATUS=0
where,
TIME: minutes of exercise;
SPM: strokes for minute;
RPM: revolutions for minute;
POWER (Wa);
DRAG FACTOR: measurement of the agility of the “boat”;
SPEED (Km/h);
PACE: time for covering a distance of 500 metres, expressed in seconds;
HR: Heart Rate;
STATUS: Not Applicable;
SKILLROW:
Technical Service Guide - Rev. 1.1
Page 50
e-mail: support@technogym.com