Technogym SKILLROW - Checking Connection Type; Enabling Dhcp; Disabling Dhcp; Writing The Console Ip Address

The parameter index indicates the number of the WEP key utilised (the permied values are 1, 2, 3
and 4). If a WEP key is not used, enter 0. Only WEP open key mode is supported.
6.2.3.4 CHECKING CONNECTION TYPE
Command Notes
Command @RWIFICONFIG#
Displays SSID, password and type of encryption
used by the congured access point.
Table 25
The parameter ssid indicates the name of the Wi-Fi network.
6.2.3.5 ENABLING DHCP
Command Notes
Command @ENABLEDHCP# Enable DHCP.
Table 26
6.2.3.6 DISABLING DHCP
Command Notes
Command @DISABLEDHCP#
Disable DHCP. Remember to congure, with
the following commands, the static IP address
of the console, the default gateway, the DNS
server and the netmask
Table 27
6.2.3.7 WRITING THE CONSOLE IP ADDRESS
Command Notes
Command @SIPADDRESS ipaddress# Sets the static IP address of the console.
Table 28
SKILLROW:
Technical Service Guide - Rev. 1.1
Page 44
e-mail: support@technogym.com