Technogym SKILLROW - Checking Dhcp; Checking The Ip Address - Default Gateway - Netmask; Reading The Wi-Fi Power

6.2.3.11 CHECKING DHCP
Command Notes
Command @RNETCONFIG#
Shows if the DHCP is active. If the DHCP is not
active it shows the congured static IP address
of the console, the default gateway and the net-
mask.
Table 32
6.2.3.12 CHECKING THE IP ADDRESS - DEFAULT GATEWAY - NETMASK
Command Notes
Command @RNETPARAM#
Displays the IP address of the console, the de-
fault gateway and the netmask the console is
currently using (regardless of whether these
have been assigned in DHCP mode or have been
congured as static).
Table 33
6.2.3.13 READING THE WI-FI POWER
Command Notes
Command @RWIFIRSSI# Shows the Wi-Fi receiving power.
Table 34
SKILLROW:
Technical Service Guide - Rev. 1.1
Page 46
e-mail: support@technogym.com