Technogym SKILLROW - Moving and Installing the Equipment; Pre-Installation Requirements; Installation Specifications And Requirements; Installation Procedure

5. MOVING AND INSTALLING THE EQUIPMENT
5.1 PRE-INSTALLATION REQUIREMENTS
 WARNING:Refertotherelativespecicmanual:SKILLROW PRE-INSTALLATION RE-
QUIREMENTS,whichcanbeconsultedonTGDIRECT.
5.2 INSTALLATION SPECIFICATIONS AND REQUIREMENTS
1. Placetheequipmentonaatandstamblesurface,wheretherearenovibrationsandwhere
theloadingbearingcapacityissucientfortheweighttobesupported,alsotakingintocon-
siderationtheweightoftheuser.
2. Checkthattheareaisnotdustyorsandy.
3. Checkthatthere’samplerangeoffreespacemeasuringatleast60cmallaroundeachpiece
ofequipment;
4. Checkthatthetemperatureandhumidityarecomplywiththetemperatureandhumidity
operatingrequirementsindicatedinparagraph:“2.3Environmentalcharacteristics”.
5. Theplaceofinstallationmustcomplywithallbindingregulations.
5.2.1 INSTALLATION PROCEDURE
Follow the assembly instructions described in the distribution logistics course, available on E-Learn-
ing.
1. Theequipment is shipped partiallydismantled, packed in cardboardpackaging. Remove
thecardboardpackaging:liftthedisplaybrackettoallowtoremovethepackaging.Then,
lowerthedisplaybracketinordertomovethecomponentA,withoutriskofbreakingofthe
display.
SKILLROW:
Technical Service Guide - Rev. 1.1
Page35e-mail: support@technogym.com