Technogym SKILLROW - The Difficulty Levels Physically Change, but the Levels on the Display Dont Change

6.6.5 THE DIFFICULTY LEVELS PHYSICALLY CHANGE, BUT THE LEVELS, ON THE
DISPLAY DON’T CHANGE
The difficulty levels physically
change, but the levels on the
display don’t change.
Update the sw at the display; then, calibrate the
equipment. Are the values correct[1] ?
Check the equipment. Make the necessary
mechanical adjustments. Then, calibrate
the equipment. Problem solved?
OK. Problem solved.
Replace the angle sensor board; then, calibrate the
equipment. If necessary, replace the cable that
connects the CPU with the angle sensor board;
Calibrate the equipment.
Yes
Yes
No
No
Figure 32
SKILLROW:
Technical Service Guide - Rev. 1.1
Page 64
e-mail: support@technogym.com