Technogym SKILLROW - The Seat Is Not Stable And Has Plays

6.6.8 THE SEAT IS NOT STABLE AND HAS PLAYS
1. Follow the procedure as described at the paragraph “7.8 disassembling seat” (from point 1 to
point 4).
2. Reposition the seat guard on the guide.
3. Loosen the nut of the eccentric a lile.
4. Regulate the eccentric, acting on the pivot of the eccentric.
Under the seat there’s only one eccentric, as indicated in the following gure. The gure serves pure-
ly as an example.
Figure 37
5. Fasten the nut, keeping xed the eccentric.
6. Remove the seat from the guide.
7. Reassemble the seat guard on the seat.
8. Reposition the seat on the guide.
ATTENTION: be careful not to damage the wheels of the seat, during the reposition of the seat.
SKILLROW:
Technical Service Guide - Rev. 1.1
Page 69e-mail: support@technogym.com