Technogym SKILLROW - Login To The Skillrow

SKILLROW:
Technical Service Guide - Rev. 1.1
Page 31e-mail: support@technogym.com
To pair the chest band, It’s necessary to press the heart shaped symbol on the right of the display.
There is a receiver in the display that receives the heart rate signals from the telemetric chest band.
The Bluetooth Smart and ANT+ transmission technologies are supported. After pressing the heart
shaped symbol, the heart icon ashes for 10 sec during the pairing operation. During this period
the system searches for a chest band. To carry out the pairing, the user must start to row.
For more details about the U-I screen, see the user manual.
The console internally contains a super condenser that allows to:
- Save the exercises when user stops rowing;
- Activate the equipment (double click on the display) without rowing, to set the exercise.
Only once it’s possible to do this procedure. However, to activate the equipment it’s suggested to
always pull the chain.
The super condenser chargers after 1m:45s of rowing equal or more than 60W.
The CPU mainboard calculates the data that are shown on the display.
The CPU mainboard contains SW upgradable.
The SN of the equipment and the SN of the console (string wrien in the adhesive QR code) are
wrien in the memory of the CPU mainboard.
If you replace the U-I, the spare part contains the console and also the adhesive QR code. The SN
of the console has been already wrien by the supplier.
The points of calibration are memorized in the CPU mainboard and depend on the angle sensor
board (potentiometer) and the assembly.
Therefore, if you replace the U-I console you must:
- Replace the old adhesive QR code with the new one;
- write the SN of the equipment in the CPU;
- congure the console;
- calibrate the equipment.
3.2.8 LOGIN TO THE SKILLROW
The login to the SKILLROW can be done in the following ways:
- Mywellness and TGS keys;
- Mywellness band and third parties (prior checking by After Sales HQ) bracelets;
- Mywellness APP via BLE and QR code;
- Mywelleness APP via NFC (only Androids telephones compatible with TagNFC);