Technogym SKILLROW - Configuring Unity Self; Setting Parameters; Setting The Time Period For Sending Data; Displaying The Unity Self Configuration

Table 36
6.2.5 CONFIGURING UNITY SELF
6.2.5.1 SETTING PARAMETERS
Command Notes
Command @SRTMSOCKET ip_add port#
Sets the IP address and the UDP port where the
Unity Self is located.
Table 37
The parameter ip_add indicates the IP address where the real-time monitor is located. The param-
eter port indicates the UDP port at which the real-time monitor is located.
6.2.5.2 SETTING THE TIME PERIOD FOR SENDING DATA
Command Notes
Command @SRTMPOLLING tsend#
Sets the time period for sending data to the Uni-
ty Self.
The parameter tsend indicates the time period for sending data to the real-time monitor (ex-
pressed in milliseconds).
6.2.5.3 DISPLAYING THE UNITY SELF CONFIGURATION
Command Notes
Command @RRTMCONFIG# Displays the conguration of the Unity Self.
Table 38
SKILLROW:
Technical Service Guide - Rev. 1.1
Page 48
e-mail: support@technogym.com