TECO F510 series - 4.2.2 Keypad Menu Structure

4-13
4.2.2 Keypad Menu Structure
 Main Menu
The F510 inverter main menu consists of two main groups (modes). The DSP/FUN key is
used to switch between the monitor mode and the parameter group mode. Refer to Figure 4.2.2.1.
Mode Description
Monitor Mode
View inverter status, signals and fault data.
Parameter Group Mode Access to available parameter groups.
All the available parameter groups are listed in the Parameter Group Mode. Use the up and
down keys to select a group and press READ/ ENTER to access its parameters.
Fig. 4.2.2.1 Parameter Group Structure
Notes:
- Always perform auto-tune on the motor before operating the inverter in vector control (sensorless vector or
flux vector). Auto-tuning mode will not be displayed when the inverter is running or when a fault is active.
- To scroll through the available modes, parameter groups or parameter list press and hold the up or down
key.
Parameter Group Mode
Parameter Mode
Parameter Edit Mode
DSP
FUN
DSP
FUN
RUN
READ
ENTER
READ
ENTER
Auto-Tune Mode
DSP
FUN
Select parameter
Change parameter setting
Auto-tune motor
Select parameter group