TECO F510 series - Engineering Units (Only for LCD)

9-4
Feedback Signal 0 – 10V (10-01 = 1) – SW2 = V
(S+) (S+) S1 S3 S5 24V +10V MT
GND
GND
AI1
AI2
E
24VG S2 S4 S6 F1 F2 PO PI AO1 AO2
E
Connect shield to
control ground terminal
0 – 10Vdc
+
-
Analog Input AI2
Common, GND
Control Terminals /
User Terminals
SW2
IV
Set switch SW2 to ‘V’
9.3 Engineering Units (only for LCD)
The PID setpoint scaling can be selected with parameter 16-03 and 16-04.
Example: 0 – 200.0 PSI Setpoint, set 16-03 to 12000 (1 decimal, range 0 – 200) and 16-04 to 2 (PSI).