TECO F510 series - Programming Mode

4-15
 Programming Mode
In programming mode inverter parameters can be read or changed. See Fig 4.2.2.3 for
keypad navigation.
Power ON
DSP
FUN
READ
ENTER
READ
ENTER
READ
ENTER
READ
ENTER
As the above
parameter setting
Monitor
Freq Ref
12-17=000.00Hz
12-18=0000.0A
12-16=005.00Hz
Control Method
Edit 00-00
0 V/F
(0~4)
<0>
Motor Direction
0 Forward
(0~1)
<0>
Run Source
0 Digital Op
(0~4)
<1>
DSP
FUN
DSP
FUN
DSP
FUN
READ
ENTER
DSP
FUN
READ
ENTER
DSP
FUN
Edit 00-01
Edit 00-02
DSP
FUN
DSP
FUN
DSP
FUN
Group
01 V/F Pa tte rn
02 Moto r Parameter
00 Basic Func.
Group
02 Moto r Para meter
00 Basic Fun.
01 V/F Pa ttern
Group
00 Basic Fun.
01 V/F Pa ttern
02 Motor Parameter
PARA 00
-00 Control Method
-01 Motor Direct ion
-02 Run Source
PARA 00
-00 Control Method
-01 Motor Direction
-02 Run Source
PARA 00
-00 Control Method
-01 Motor Direct ion
-02 Run Source
Parameter Gr oup
Selection Mode
Parameter
Group Mode
Parameter
Edit Mode
DSP
FUN
Press▼ / ▲ to
edit the setting
value or
READ/ENTER
to save the
changes.
Monitor Mode
Fig 4.2.2.3 Programming Mode
Notes:
- The parameters values can be changed from the data set/read screen with the ▲ (up) or ▼ (down)
and < / RESET shift key.
- To save a parameter press the READ/ENTER key. Return to the previous sub-menu screen press
DSP/FUN key.
- Press the ▲ (up) or ▼ (down) key to scroll parameter groups or parameter list. When pressing
DSP/FUN in the parameter edit mode, it will return to the previous screen of parameter group mode;
when pressing
DSP/FUN in the parameter group mode, it will return to the previous screen of
parameter group selection mode.
-
Refer to section 4.4 for parameter details.