TECO F510 series - 3.2.4 Removing the Front Cover and Keypad

3-8
3.2.4 Removing the Front Cover and Keypad
 Before making any wiring connections to the inverter, the front cover needs to be
removed.
IP00/ IP20 Type
Caution
 It is not required to remove the digital operator before making any wiring connections.
 Models 200V,1– 30 HP and 400V, 1 – 40 HP have a plastic cover. Loosen the screws
and remove the cover to gain access to the terminals and make wiring connections.
Place the plastic cover back and fasten screws when wiring connections have been
made.
 Models 200V, 40 - 175HP and 400V, 50 - 800HP have a metal cover. Loosen the
screws and remove the cover to gain access to the terminals and make wiring
connections. Place the metal cover back and fasten screws when wiring connections
have been made.
IP55 Type
Caution
 It is essential to remove the digital operator before making any wiring connections.
 Model 400V, 1 – 25 HP has a plastic cover. Loosen the screws and remove the cover to
gain access to the terminals and make wiring connections. Place the plastic cover back
and fasten screws when wiring connections have been made, suggested screw locking
torque is 8 kgf-cm.
 Models 400V, 30 - 100HP has a metal cover. Loosen the screws and remove the cover
to gain access to the terminals and make wiring connections. Place the metal cover
back and fasten screws when wiring connections have been made, suggested screw
locking torque is 8 kgf-cm.