TECO F510 series - 4.1.1 Keypad Display and Keys

4-3
4.1.2 Seven Segment Display Description
Actual LED Display Actual LED Display Actual LED Display Actual LED Display
0 A L Y
1 B n
-
2 C o
°
3 D P _
4 E q .
5 F r
6 G S
7 H t
8 I u
9 J V
Display output frequency Frequency Reference Set Frequency Reference
LED lights on LED flashes Flashing digit
 At power-up, the display will show the frequency reference setting and all LEDs are flashing. Press
the ▲ (UP) or ▼ (DOWN) key to enter the frequency reference edit mode, use the ◄/RESET key
to select which digit to edit (flashing). Use the ▲ (UP) or ▼ (DOWN) key to modify the value and
press the READ / ENTER key to save the frequency reference and switch back to the frequency
reference display mode.
 During run operation, the display will show the output frequency.
Note: When in edit mode and the READ / ENTER is not pressed within 5 sec, the inverter will switch
back to the frequency reference display mode.