TECO F510 series - Built-In PLC Function; Basic Command

4-309
4.5 Built-in PLC Function
The PLC ladder logic can be created and downloaded using the TECO drive link software.
4.5.1 Basic Command
 
P NO / NC
Inputs
I
i I1I6 / i1i6
Outputs
Q Q Q Q Q q Q1Q2 / q1q2
Auxiliary command
M M M M M m M1MF / m1mF
Special registers
V1~V8
Counter function
C C c C1~C8 / c1~c8
Timer function
T T t T1T8 / t1t8
Analog comparison function
G G g G1G8 / g1g8
Operation control function
F F f F1~F8 / f1~f8
summation and subtraction
function
AS AS1~4
Multiplication and division
function
MD MD1~4
Description of registers
V1：Set frequency Range：0.1~400.0Hz
V2：Operation frequency Range：0.1~400.0Hz
V3：AI1 input value Range：0~1000
V4：AI2 input value Range：0~1000
V5：Keypad input value Range：0~1000
V6：Operation current Range：0.1~999.9A
V7：Torque value Range：0.1~200.0%
V8：PID Target Value Range：0.1~400.0Hz
Command Upper Differential Lower Differential
Other command
symbol
Differential command
D d
SET command

RESET command

P command
P
Open circuit
“ “
Short circuit
“--”
Connection symbol Definition
─
Connect components on the left and right side
┴
Connects components on the left , right and top side
┼
Connects components on the left , right , top and bottom side
┬
Connects components on the left , right and bottom side