7-1
Chapter 7 Operation Method Configuration (Run / Stop)
The inverter offers users several choices to run and stop from different sources. The most commonly
used methods are described in the next sections.
Operation command is selected with parameter 00-02.
00-02: Run Command Selection
This function sets the frequency command source.
Setting Range: 0 to 3
To set parameter 00-01:
- After power-up press the DSP/FUN key
- Select 00 Basic Fun
- Press READ/ ENTER key
- Select parameter -01 with the UP/DOWN ▲ and ▼ keys and press the READ/ ENTER key.
In the parameter list move cursor to 00-01 with the UP/DOWN keys and press READ/ ENTER key to
select.
00-02 Run Command Selection
Range
0: Keypad control
1: External terminal control
2: Communication control
3: PLC
4: RTC
7.1 Run/Stop from the Keypad (00-02=0) – Default Setting
Use the RUN key to run the drive in forward direction and the
FWD/REV key to change the motor direction. (Note: to disable
reverse direction set parameter 11-01 to 1)
Press STOP key to stop the inverter. (Note: Stop method can be set
with parameter 07-09, default is deceleration to stop).
Fref Ref
12-16=005.00Hz
Monitor
12-17=00 0.00 Hz
12-18=00 00.0A
To Next Page
Loading...
