TECO F510 series - Page 147

4-58
Group 16: LCD Function Parameters
Code Parameter Name Setting Range Default Unit
Control Mode
Attribute
V/F SLV
PM
SLV
10: /h
11: °F
12: inW
13: HP
14: m/s
15: MPM
16: CMM
17: W
18: KW
19: m
20: °C
21: RPM
22: Bar
23: Pa
24: KPa
Note4
16-05 LCD Backlight 0~7 5 - O O O *1
16-06 Reserved
16-07 Copy Function Selection
0: Do not copy parameters
0 - O O O
1: Read inverter parameters and
save to the operator.
2: Write the operator parameters to
inverter.
3: Compare parameters of inverter
and operator.
16-08 Selection of Allowing Reading
0: Do not allow to read inverter
parameters and save it to the
operator.
0 - O O O
1: Allow to read inverter
parameters and save it to the
operator.
16-09
Selection of Operator
Removed (LCD)
0: Keep operating when LCD
operator is removed.
0 - O O O *1
1: Display fault to stop when LCD
operator is removed
16-10 RTC Time Display Setting
0: Hide
0 O O O
1: Display
16-11 RTC Date Setting 12.01.01 ~ 99.12.31
12.01.0
1
O O O
16-12 RTC Time Setting 00:00 ~ 23:59 00:00 O O O
16-13 RTC Timer Function
0: Disable
0 O O O 1: Enable
2: Set by DI
16-14 P1 Start Time 00:00 ~ 23:59 08:00 O O O
16-15 P1 Stop Time 00:00 ~ 23:59 18:00 O O O
16-16 P1 Start Date
1:Mon, 2:Tue, 3:Wed,
4:Thu,:5:Fri,:6:Sat,
1 O O O
16-17 P1 Stop Date 5 O O O