TECO F510 series - Page 239

4-150
05-05 *Frequency Setting of Speed- Stage 4 *1
Range 【0.0~400.00】 Hz
05-06 *Frequency Setting of Speed- Stage 5 *1
Range 【0.0~400.00】 Hz
05-07 *Frequency Setting of Speed- Stage 6 *1
Range
【0.0~400.00】 Hz
05-08 *Frequency Setting of Speed- Stage 7 *1
Range 【0.0~400.00】 Hz
05-09 *Frequency Setting of Speed- Stage 8 *1
Range 【0.0~400.00】 Hz
05-10 *Frequency Setting of Speed- Stage 9 *1
Range
【0.0~400.00】 Hz
05-11 *Frequency Setting of Speed- Stage 10 *1
Range 【0.0~400.00】 Hz
05-12 *Frequency Setting of Speed- Stage 11 *1
Range 【0.0~400.00】 Hz
05-13 *Frequency Setting of Speed- Stage 12 *1
Range
【0.0~400.00】 Hz
05-14 *Frequency Setting of Speed- Stage 13 *1
Range 【0.0~400.00】 Hz
05-15 *Frequency Setting of Speed- Stage 14 *1
Range 【0.0~400.00】 Hz
05-16 *Frequency Setting of Speed- Stage 15 *1
Range
【0.0~400.00】 Hz
【0.1~6000.0】 Sec
*: (When the motor’s maximum output frequency is over than 300Hz, the frequency resolution is
0.1Hz.)
*1: It isnew added in inverter software V1.4. Parameters 05-02~05-16 is required to set the
frequency in parameters 06-01~06-15 in inverter software V1.3.
05-17
Acceleration time setting for multi speed 0
Range
【
0.1~6000.0】 Sec
05-18
Deceleration time setting for multi speed 0
Range
【
0.1~6000.0】 Sec