TECO F510 series - Page 272

4-183
08 - 46
Temperature agree level
Range
【0 ~ 254】°C
08 - 47
Temperature reset level
Range
【0 ~ 254】°C
Note: 08-47 maximum value will be limited by 08-46 set value
The inverter temperature agree and reset level selection
‧ 03-11 set to【59】:
‧ 08-46: The inverter temperature is > 08-46, the relay operates.
‧ 08-47: When the output current is ≤ 08-47, the relay signal from ON to OFF.
Down time frequency diagram:
08-46
03-11
繼電器
ON
變頻器溫度
T(°C)
Time
08-47
Inverter temperature agree and reset detection
08 - 48
Selection of Fire Mode
Range
【0】: Disable
【1】: Enable
08 - 49
Multi-Function Input Terminal Status of Fire Mode
Range
【0】: Reset after Power Off
【1】: Reset after Terminal Removed
08 - 50
Multi-Function Terminal Status of Fire Mode
Range
【xxx0b】: S6 A Contact
【xxx1b】: S6 B Contact
08 - 51
Motor Speed Setting Source of Fire Mode
Range
【0】：Fire Mode Speed (08-52)
【1】：PID Control
【2】：AI2
08 - 52
Fire Mode Motor Speed
Range
【0.00~100.00】%
08 - 59
Fire Mode Motor Direction
Range
【0】: Forward
【1】: Reverse
08 - 60
Fire Mode Password
Range
【00000 ~ 65534】
 When 08-48=0, Fire Mode is disabled.
Frequency Converter Temperature
Relay