TECO F510 series - Page 282

4-193
Figure 4.4.70 Basic PID control
PID Setup
Enable PID control by setting parameter 10-03, PID target value (10-00) and PID feedback value (10-01).
10-00: PID target value
= 0: keypad given
= 1: analog AI1 given (default)
= 2: analog AI2 given
= 3: Reserved
= 4:10-02
10-01: PID feedback value
= 1: Analog AI1 given
= 2: Analog AI2 given
= 3: Reserved
Figure 4.4.71 PID input selection