7. PROGRAMRAMMING
7.1 INTRODUCTION
Teknim PARS series panels have two programming sections.
“Installer Program” <InP> It provides access to the engineering settings of the system. Login with
engineering code.
“Master Program” <MaP> It provides access to the main user settings menus such as date, time,
phone numbers and user codes. Login with master code.
Program addresses of Teknim PARS series panels are grouped according to their subjects.
Addresses are a four-digit number and the first two digits indicate this topic. The last two digits
include zone no, user no, keypad no. determines the detail. Basic Settings gathers the settings that
need to be made in simple setups. Thus, it is aimed to provide convenience to the installer.
Basic Settings : 01 XX -Time/Date Settings
02 XX -Entrance Delays
03 XX -Exit Delays
04 XX -CMS Accounts
05 XX -CMS Phones
06 XX -User Phones
07 XX -User Codes
Panel Settings: 10 XX -General Settings
11 XX -Siren Settings
12 XX -Auto Arm/Disarm
13 XX -PGM Settings
14 XX -Timer Settings
15 XX -Remote Access
Zon Settings: 20 XX -Connection Type
21 XX -Partition
22 XX -Zon Type
23 XX -Extra Settings
24 XX -Response Time
25 XX -Zone Names
Keypad Settings: 30 XX -Keypad Options
31 XX -Partitions
99 XX -Customize
User Settings: 40 XX -Start Time
41 XX -Finish Time
42 XX -Days
43 XX -Partitions
44 XX -Keypads
45 XX -Limitations
Communicator: 50 XX -General Options
51 XX -Report Masks
Modules: 60 XX -Remote Module
61 XX -Remote Module Erase
To Next Page
Loading...
