Power Report Delay
In this section, you can set how many minutes after the power failure information will be notified to
the user and the CMS. A value can be entered between 0-60min.
• LED Keypad; [10] [05] → [DD] → [√ OK]
• LCD Keypad; [Panel Settings √ OK] → [General Settings √ OK] → [Power Report Delay DD] → [√ OK]
Double Trigger Time
Double trigger time starts when one of the detectors with this feature is activated (to set this
feature to a detector see 7.5.4 Extra Settings). The first activation will not assign as an alarm. If
another zone which selected as cross zone or double trigger in the same partition activated in the
Double trigger time period, panel gives alarm and send the information to CMS or users.
If there will be no second activation after the first one, system gives “Cross Zone Fault”.
• LED Keypad; [10] [06] → [DD] → [√ OK]
• LCD Keypad; [Panel Settings √ OK] → [General Settings √ OK] → [Double Trigger Time DD] → [√ OK]
7.4.2 Siren Settings
This is the section where the siren settings are made.
Siren Using Partitions
You can select which partitions are using siren.
• LED Keypad; [11] [01] → [1-2-3-4] → [√ OK]
• LCD Keypad; [Panel Settings √ OK] → [Siren Settings √ OK] → [Siren Settings Partitions A-B-C-D] → [√ OK]
Cut Off Time
You can select how many minute siren will work during alarm. Can be set between 2 – 255min.
• LED Keypad; [11] [02] → [DD] → [√ OK]
• LCD Keypad; [Panel Settings √ OK] → [Siren Settings √ OK] → [Cut Off Time DD] → [√ OK]
7.4.3 Auto Arm/Disarm
This is the section where the alarm system can be set up for any Partition to automatically arm and
disarm on certain days and times of the week.
Auto Arm Partitions
You can set which partitions will be Arm automatically.
• LED Keypad;
[12] [01] → [1-2-3-4] → [√ OK]
• LCD Keypad;
[Panel Settings √ OK]→[Auto Arm/Disarm √ OK]→[Auto Arm Partitions A-B-C-D]→[√ OK]
To Next Page
Loading...
