Teknim PARS Series - Panel Settings; General Settings

TEKNİM PARS SERIES INTRUDER ALARM SYSTEM INSTALLATION AND PROGRAMMING MANUAL
26 / 81
• LCD Keypad;
[Basic Settings √ OK] → [User Codes √ OK] → [01-User Code XXXX] → [√ Ok]
[Basic Settings √ OK] → [User Codes √ OK] → [02-User Code XXXX] → [√ Ok]
[Basic Settings √ OK] → [User Codes √ OK] → [03-User Code XXXX] → [√ Ok]
[Basic Settings √ OK] → [User Codes √ OK] → [04-User Code XXXX] → [√ Ok]
[Basic Settings √ OK] → [User Codes √ OK] → [05-User Code XXXX] → [√ Ok]
[Basic Settings √ OK] → [User Codes √ OK] → [06-User Code XXXX] → [√ Ok]
[Basic Settings √ OK] → [User Codes √ OK] → [07-User Code XXXX] → [√ Ok]
[Basic Settings √ OK] → [User Codes √ OK] → [08-User Code XXXX] → [√ Ok]
[Basic Settings √ OK] → [User Codes √ OK] → [09-User Code XXXX] → [√ Ok]
[Basic Settings √ OK] → [User Codes √ OK] → [10-User Code XXXX] → [√ Ok]
[Basic Settings √ OK] → [User Codes √ OK] → [11-Threat (Duress) Code XXXX] → [√ Ok]
eg. To set 1
st
user code as 1111; [07] [1] [1111] [√ OK]
To set 2
nd
user code as 2222; [07] [2] [2222] [√ OK]
Master and Installer codes do not have an address. Master code factory default is “1234”, and
installer code factory default is “9999”. You can change these codes as follows.
• [√ Press and Hold] → [Enter Existing 4 Digit Code XXXX] → [New Code XXXX] → [Repeat New Code XXXX]
eg. To set Master code as 9876; [√ Hold] [1234] [9876] [9876]
To set Installer code as 4321; [√ Hold] [9999] [4321] [4321]
PS: The code changes for the LCD and LED Keypad are the same, and you do not need to press the
[√ OK] key at the end of the process.
PS 2: Threat Code only “Disarm” the system and send Alarm information to user phones and CMS
7.4 PANEL SETTINGS
This section contains the detailed settings of the control panel.
7.4.1 General Settings
General settings related to the panel.
Panel Options
Option
2.
3.
4.
5.
6.
Function
Quick Arm
Auto Siren Test
Arm – Disarm From
Different Keypad
Exit Delay
Extension
Double Hit
LED ON
ON
ON
ON
ON
ON
LED OFF
OFF
OFF
OFF
OFF
OFF
Quick Arm: When this option is active, you can use A – B – C – D keys to Quickly Arm the related
partition by press and hold the key.
Auto Siren Test: When this option is active, system gives warning with 2sec. siren sound when it’s
armed.
Arm – Disarm From Different Keypad: When this option is active, users can use the keypads that
are authorized in other partition. When it is off, the keypad cannot process any partition which is not
belong to.