Teknim PARS Series - 10 Tests; Cms Call Test; User Call Test; Si̇ren Testi̇

TEKNİM PARS SERIES INTRUDER ALARM SYSTEM INSTALLATION AND PROGRAMMING MANUAL
63 / 81
10. TESTS
This is where you can test some system settings.
Press [Fx] and [8] key to enter test menu and enter your 4-digit code.
PS: You should enter Installer Code or Master code to enter Test menu. Other user codes will not
work to enter this menu.
10.1 CMS CALL TEST
To test Central Monitoring Station reports proceed following process.
• LED Keypad;
[Fx] [8] → [Code XXXX] → [1] [1] → [√ OK] (1. CMS Test)
[Fx] [8] → [Code XXXX] → [1] [2] → [√ OK] (2. CMS Test)
• LCD Keypad;
[Fx] [8] → [Code XXXX] → [1-CMS Test Call]→[√ OK]→[1] (1. CMS Test)
[Fx] [8] → [Code XXXX] → [2-CMS Test Call]→[√ OK]→[1] (2. CMS Test)
To exit test menu press [X] key.
10.2 USER CALL TEST
To test user calls proceed following process.
• LED Keypad;
[Fx] [8] → [Code XXXX] → [2] [1] → [√ OK] (1. User Call Test)
[Fx] [8] → [Code XXXX] → [2] [2] → [√ OK] (2. User Call Test)
• LCD Keypad;
[Fx] [8] → [Code XXXX] → [2- Prvt. Test Call]→[√ OK]→[1] (1. User Call Test)
[Fx] [8] → [Code XXXX] → [2- Prvt. Test Call]→[√ OK]→[2] (2. User Call Test)
To exit test menu press [X] key.
10.3 SİREN TESTİ
To test siren, proceed following process.
• LED Keypad;
[Fx] [8] → [Code XXXX] → [3] [1] → [√ OK] (1. Siren Test)
[Fx] [8] → [Code XXXX] → [3] [2] → [√ OK] (2. Siren Test)
• LCD Keypad;
[Fx] [8] → [Code XXXX] → [3- Siren Test]→[√ OK]→[1] (1. Siren Test)
[Fx] [8] → [Code XXXX] → [3- Siren Test]→[√ OK]→[2] (2. Siren Test)
To exit test menu press [X] key.