7.3.2 Entrance Delays
This is the delay time (second) for the user to disarm the system. Separate times can be defined for
each partition.
Entrance Delay for Partition A;
• LED Keypad; [02] [01] → [SS] → [√ OK]
• LCD Keypad; [Basic Settings √ OK]→[1- Part Entrance Delay √ OK]→[SS]→[√ OK]
Entry Delay for Partition B;
• LED Keypad; [02] [02] → [SS] → [√ OK]
• LCD Keypad; [Basic Settings √ OK]→[2- Part Entrance Delay √ OK]→[SS]→[√ OK]
Entry Delay for Partition C;
• LED Keypad; [02] [03] → [SS] → [√ OK]
• LCD Keypad; [Basic Settings √ OK]→[3- Part Entrance Delay √ OK]→[SS]→[√ OK]
Entry Delay for Partition D;
• LED Keypad; [02] [04] → [SS] → [√ OK]
• LCD Keypad; [Basic Settings √ OK]→[4- Part Entrance Delay √ OK]→[SS]→[√ OK]
eg. To set Entrance Delay for Partition A as 10sec. ; [02] [01] [10] [√ OK]
7.3.3 Exit Delays
This is the delay time (second) for the user to leave the place after arming the system. Separate
times can be defined for each partition.
Exit Delay for Partition A;
• LED Keypad; [03] [01] → [SS] → [√ OK]
• LCD Keypad; [Basic Settings √ OK]→[1- Part Exit Delay √ OK]→[SS]→[√ OK]
Exit Delay for Partition B;
• LED Keypad; [03] [02] → [SS] → [√ OK]
• LCD Keypad; [Basic Settings √ OK]→[2- Part Exit Delay √ OK]→[SS]→[√ OK]
Exit Delay for Partition C;
• LED Keypad; [03] [03] → [SS] → [√ OK]
• LCD Keypad; [Basic Settings √ OK]→[3- Part Exit Delay √ OK]→[SS]→[√ OK]
Exit Delay for Partition D;
• LED Keypad; [03] [04] → [SS] → [√ OK]
• LCD Keypad; [Basic Settings √ OK]→[4- Part Exit Delay √ OK]→[SS]→[√ OK]
Ör: To set Exit Delay for Partition A as 15sec. ; [03] [01] [15] [√ OK]
To Next Page
