7.10 LEARN AND CHANGE THE KEYPAD ADDRESS
The factory default for the keypad address is 1. If multiple keypads are used in the system, their
addresses must be different.
To change the keypad's address, the following operation is performed while the keypad in the
normal position.
[Press and Hold 4] → [Enter Keypad Address X] → [√ OK]
(Keypad address may given as 1, 2, 3 and 4)
To see the address of the keypad, the following operation is performed while the keypad in the
normal position.
LCD Keypad;
[Press and Hold 6] → [Master Code XXXX] → [4- Keypad Address] → [√ OK] Shown Keypad Address.
LED Keypad;
[Press and Hold 6] → [Master Code XXXX] → [Press 4] Shown Keypad Address.
To Next Page
Loading...
