LED 05 01 (wait)
LCD 0-BASIC SETTINGS → CMS PHONES → 01-CMS PHONE NR (wait)
To change value :
LED 05 01 R R......... R R √
LCD 0-BASIC SETTINGS → CMS PHONES → 01-CMS PHONE NR
R R......... R R √
R R........R R = Central Monitoring Station Phone Number ,(maximum 15 digit)
Default value : ---
Example : To set CMS-1 Phone Number to 0216 123 45 67 do
“ 05 01 0 216 1234567 √ “
o Central Monitoring Station-1 (CMS-1) Secondary Phone Number
Address= 05 03 < IP >
To see value :
LED 05 03 (wait)
LCD 0-BASIC SETTINGS → CMS PHONES → 03-CMS PHONE NR (wait)
To change value :
LED 05 03 R R......... R R √
LCD 0-BASIC SETTINGS → CMS PHONES → 03-CMS PHONE NR
R R......... R R √
R R........R R = Central Monitoring Station Phone Number ,(maximum 15 digit)
Default Value : ---
Example : To set CMS-1 Secondary Phone Number to 0216 123 45 67 do
“ 05 03 0 216 1234567 √ “
8.1.6. User Phone Numbers
There are 6 user phone numbers in VAP404 Panel. If user doesn’t answer phone or doesn’t enter code
(*XXXX) panel calls following number also you can select numbers that will be called in all conditions (Look
at Event Logs section). You can select phone numbers connected to partition/s or out of partition (Look at
addresses of 50 16-20). Panel tries to call same number as the number of dial attempt after than continue to
call selected phone numbers. If 7.option in 50 01 is selected, panel cancels to call other phone numbers after
confirmation(Each partition needs confirmation to cancel their own calls ).
Note: User phone dialer is enabled (2. option in 50 01) automatically when any of user phone number
( 06 01 06 06 ) is entered.
o 1ST User Phone Number
Address=06 01 < IP, MP >
To see value :
LED 06 01 (wait)
LCD 0-BASIC SETTINGS → PRIVATE PHONES → 01-USER PHONE NR (wait)
To change value :
LED 06 01 R R........ RR √
LCD 0-BASIC SETTINGS → PRIVATE PHONES → 01-USER PHONE NR R R......... R R √
R R........R R = User Phone Number ,(maximum 15 digit)
Default Value : ---
Example : To set First dialer number to 0216 123 45 67 do
“ 06 01 0 216 1234567 √ “
Press 0 (long) to add duration time.
“ 06 01 9 0(long) 216 1234567 √ “
o 2ND User Phone Number
Address= 06 02 < IP, MP >
Default Value : ---
To Next Page
Loading...
