Events that is not belongs to any Partition
Address = 50 11 < IP >
To see value :
LED 50 11 (wait)
LCD 5-COMMUNICATOR→ GENERAL SETTINGS → COMMON CMS(wait)
To change value :
LED 50 11 S S √
LCD 5-COMMUNICATOR → GENERAL SETTINGS → COMMON CMS
S S √
S S = Multi-choice selection 1, 2
Default Value : 1 =ON
Example : To send messages CMS-1 and CMS-2 do “ 50 11 1(ON) 2(ON) √ “
Events that is belongs to A D Partition
Address : 50 12-15 < IP >
Default Value : 1 (ON) (CMS-1)
o User Phone Selection that Messages will be Sent to
This setting defines which events will be sent to which Phone number. Arm/Disarm, alarms, bypass events,
zon troubles are called related to their partitions.
Note: Keypad alarms(Panic, Fire, Duress, Tamper) aren’t belong to any partition.
Meanings of options as following;
Events that is not belong to any Partition
Address : 50 16 < IP >
To see value :
LED 50 16 (wait)
LCD 5-COMMUNICATOR→ GENERAL SETTINGS → PARTITION A CMS (wait)
To change Value :
LED 50 16 S S S S S S √
LCD 5-COMMUNICATOR → GENERAL SETTINGS → PARTITION A CMS
S S S S S S √
S S S S S S : Multi-choice selection, (1, 2, 3, 4, 5, 6)
Default Value : All selection is ON
Example : To select all phones do
“ 50 16 1(ON) 2(ON) 3(ON) 4(ON) 5(ON) 6(ON) √ “
Events belong to A D Partition
Address = 50 17-20 < IP >
Default Value : All options are ON
8.6.2. Event Logs
Installer decides which event will be informed to Central M. Station1-2 and/or user1 to 5 and/or Memory.
Events are separated into 3 groups. These are Alarms, Troubles, and Events. Meaning of options is in the
following table.
To Next Page
