o 3RD User Phone Number
Address= 06 03 < IP, MP >
Default Value : ---
o 4TH User Phone Number
Address 06 04 < IP, MP >
Default Value : ---
------------
o 6TH User Phone Number
Address= 06 06 < IP, MP >
Default Value : ---
8.1.7. Assigning & Changing User Codes
User codes can be assigned/changed in Master Program. When entered users code, that user becomes
enabled. If “0000” is entered as user code, that user becomes disabled.
o User Code-1
Address = 07 01 < MP >
To change value :
LED 07 01 YYYY √
LCD 0-BASIC SETTINGS → USER CODES → 01-USER CODE
YYYY √
YYYY = User Code between 0001 and 9999 (0000 means that user becomes disabled).
Default Value : 0000= Disabled
Example : To assign user code-1 as 2345 do “ 07 01 2345 √ “
o User Code-2
Address = 07 02 < MP >
Default Value : 0000=Disabled
o User Code-3
Address = 07 03 < MP >
Default Value : 0000=Disabled
o User Code-4 5
Address = 07 04 05 < MP >
Default Value : 0000=Disabled
o Guest Code
Address = 07 06 < MP >
Default Value : 0000=Disabled
o Duress Code
Address = 07 07 . < MP >
Default Value : 0000=Disabled
Note: Duress Code is not valid if communicator(Central Monitoring Station calling) and dialer (user calling) is
disabled or if there is no phone line connected panel.
o PC Connection Code
Address = 07 08 . < MP >
Default Value : 7777
User can simply change codes(includes Installer and Master codes) by entering following in Standby mode.
√ (Password) (long) XXXX YYYY YYYY √
XXXX = old code, YYYY = new code
Note: Duress code and PC connection code can only be assigned/changed in master program.
To Next Page
Loading...
