Teknim VAP404 - Contact ID Event Codes

TD-1/07-008
68 / 83
39-
41
----
-
-
-
-
IP
42
AC Restored
-
-
-
A= - , B= -
IP
43-
44
---
-
-
-
-
IP
45
Battery Restored
-
-
-
A= - , B= -
IP
46
Phone Line Restored
-
-
-
A= - , B= -
IP
47
Battery Connected/Restored
-
-
-
A= - , B= -
IP
48
---
-
-
-
-
IP
49
Special Arming
-
-
-
A= Arming Type (1)
B= -
IP
50
Alarm Armed
-
-
-
A= Keypad No/
Parameter,(2)
B= User No
IP
51
Bypass Canceled
-
-
-
A= - , B= Zone
IP
52-
62
---
-
-
-
-
IP
Note: (1) A = 1 ( Quick Arm ) (2) A = 1 ( Arm/ Disarm by Keypad 1 )
2 ( Arming on No Activity ) 2 ( Arm/ Disarm by Keypad 2 )
3 ( Automatic Arm/Disarm ) 3 ( Arm/ Disarm by Keypad 3 )
4 ( Arm/Disarm by Key input ) 4 ( Arm/ Disarm by Keypad 4 )
7 ( Arm/Disarm by remote controller ) 5 ( Arm/ Disarm by phone )
6 ( Arm/ Disarm by PC )
(3) A = 0 ( Factory Defaults have been loaded by Keypad )
1 ( Factory Defaults have been loaded by Vapman )
B = 1 ( Codes have been returned to factory defaults )
2 ( Panel Settings have been returned to factory defaults )
3 ( Both Panel Settings and Codes have been returned to factory defaults )
8.6.3. Contact ID Event Codes
These codes are sent to Central Monitoring Station. If codes used by Central Monitoring Station are different
from default codes, enter new codes to panel.
Default Communication Format is Contact ID
VAP404 event-codes constitute of 4 digits. Meaning of parameters is in the following.
Zone parameters;
001 = Zone 1 002 = Zone 2 003 = Zone 3 004 = Zone 4 ..... 008=Zone 8
Parameter of Keypad Panic, Fire, Duress and Keypad Tamper alarm is “000”. Paremeter of Remote
Controller Panic alarm is “000”.
User parameters:
000 = Installer 001 = Master 002 = User-1 003 = User-2 004 = User-3 005 = User-4
006 = User-5 007 = Guest
Default Contact ID codes can be changed as below.
o Intruder Alarm Code
Address = 52 01 . < IP >
To see value :
LED 52 01 (wait)