5.2. ENTERING / EXITING INSTALLER & MASTER PROGRAM
Press Program button until you hear long beep and enter installer code then device enters “Installer
Program”. Program led lights and Ready light flashes in LED Keypad. LCD Keypad displays “INSTALLER
MENU”.
4 (Program)(long) 9 9 9 9 Default Installer Code = 9999
Press Program button until you hear long beep and enter master code then device enters “Installer
Program”. Program and Ready light flashes in LED Keypad. LCD Keypad displays “MASTER MENU”.
4 (Program)(long) 1 2 3 4 Default Master Code = 1234
To exit programming mode, press Exit button long until you hear long beep then Program light becomes
OFF and LCD screen returns stand by mode.
X (Exit) (long)
Panel exits Programming mode if you don’t press any button within 3 minutes.
5.3. CHANGING CODES
User can simply change codes(except Duress code and PC connection code) by entering following in
Standby mode.
√ (Password) (long) XXXX YYYY YYYY √
XXXX = old code, YYYY = new code
5.4. ASSIGNING / DISPLAYING KEYPAD ADDRESS
Default Keypad Address is “1”. If more than one keypad will be used, Keypad addresses must be different
each other. Do following to change Keypad address ;
4 (long) Address √ (Address = 1, 2, 3, 4 )
Do following to see Keypad address ;
6 (long) 4
Keypad displays its address by zone lights on LED Keypad. LCD Keypad displays its address on screen.
5.5. PROGRAMMING ADDRESSES
To Next Page
Loading...
