Introduce a telephone line fault warning indication delay. The
time is set in minutes. The availability of a telephone line is not
tested if the preset value is 0. After resetting the communicator
the preset default value is 15 minutes.
Set the options for the performance of the dialer in this menu.
* All active parameters in the system are marked with the
“*” symbol and the inactive - with the “-” symbol. Press
the
button of the keypad to change the parameter status
of the respective submenu.
The “Wait Dialtone” option is used to wait for the dial tone
signal before dialling a telephone.
Data can be exchanged by dialling the UDL number (up-down-
load) from the system where a “Call Back” option has been
set.
The “Ans Mash” option has to be activated if there is a de-
vice for recording of voice messages (answering machine) con-
nected to the telephone line after the digital communicator of
the control panel . The device (answering machine) has to be
set to answer the incoming calls at a lower number of rings
than the digital communicator of the control panel. Then the re-
cording device (answering machine) will switch on before the
communicator of the control panel . If within a 3-minute period
there is a second incoming call the communicator will switch
on immediately.
The “Code 6 Dig” option is not in use for this software ver-
sion. There are no set options following reset.
Additional alarm system transmission options using protocol
SIA have been preset in the menu. Programming is done by
pressing the
button, as described in §3.
- SIA Hi Speed - modem transmission speed to the central
station (parameter value is 110b/s if unset);
- SIA Ext Area - transmission from modier about event
group;
- SIA Ext Time - transmission from modier about hour of
event;
- SIA Ext Date - transmission from modier about date.
There are no set options following reset.
Set the hour for transmitting an automatic test to a central sta-
tion. Set a number between 0 and 23. Following a system reset
the test hour will be 12.
Set the minute for transmitting an automatic test to the monitor-
ing station. Set a number between 0 and 59. Following a system
reset the introduced minute shall be 01.
3)Line break
4)Common flags
5)Expand SIA
6)Hour test
7)Minute test
To Next Page
