Televes 769501 - Page 111

EN
111
Figure 5-128: Advanced Setup, Routing- Policy Routing Setting window- current conguration
5.6.8.5 RIP/OSPF
Selection of Advanced Setup submenu Routing, item RIP/OSPF will display a Routing-RIP Conguration window, Figure 5-129.
This window allows the conguration of the:
RIP
OSPF
A short on line help text is provided in the conguration window.
Figure 5-130 provides a RIP and OSPF conguration example.
In order to congure RIP for the WAN Interface, Figure 5-130:
STEP 1. Select the desired RIP version at the column “Version” from the combo box
STEP 2. Select the desired operation mode at the column “Operation” from the combo box;
If the selected interface has NAT enabled, the only operation mode that can be congured is Passive;
STEP 3. At the column enabled select the Enabled checkbox
To nalize the RIP conguration use the Apply/Save button at the bottom of the window.
In order to congure and activate the OSPF, at the OSPF conguration table, Figure 5-130:
Note: OSPF cannot be congured on the WAN interface which has NAT enabled ( such as PPPoE)
STEP 1. Select the option Enabled OSPF;
STEP 2. Type in the Router IP address at the box Router id;
STEP 3. Type in the Network IP address and Mask;
STEP 4. Type in the OSPF area ID at the Area ID column;
To nalize the OSPF conguration use the Apply/Save button at the bottom of the window.
To add a new OSPF conguration, use the Add Entry button; a new line is added to the table.