Transmitter Status LED Meaning
LED status Meaning
White During startup
Green System operating normally
Blinking blue Updating system
Blinking green Emergency
Red Indicates an error
Yellow Fallback mode
Reset The Lingua IR Transmitter
There is a reset button on the transmitter that allows you to reset specific settings depending on the reset
procedure you perform:
RESET NETWORK SETTINGS:
When the status LEDis green (after power-up), you can reset the network settings back to 192.168.0.140
with subnet mask 255.255.255.0. Press and hold the reset button until the status LED changes to red
(approximately 10 seconds). After you release the reset button, the transmitter will reboot with the default
network settings.
FACTORY RESET
When you perform a factory reset you reset network settings and all configurations. Press and hold
the reset button before switching on the power of the transmitter. Hold the reset button until the status
LED turns blue. Release the reset button to reboot the transmitter in fallback mode.
In fallback mode, the web server will have reduced functionalities. You are only able to upload an update
file. After reboot, the web server will have all functionalities again. Now, upload the update file again to
complete the update process of the firmware. After the final reboot, you can create new configurations.
LING UA IR TRANSMITTER 22
To Next Page
Loading...
