Page | 94
If the microphone with number ‘002’ goes into request mode, then
the following message is sent to the control panel from the central
unit: %1D0020137. The control panel must acknowledge this
command by sending the ACK character back to the central unit.
When all microphones should be turned of, then the following
command is sent to the control panel from the central unit:
%1E000D6. The control panel must acknowledge this command by
sending the ACK character back to the central unit.
When the control panel wants the central unit to activate a
microphone, for instance the microphone with number ‘002’, then
the following command is sent: %1T0020147. The central unit will
acknowledge this command by sending the ACK character back to
the control panel.
To Next Page
Loading...
